Enamel reactor manufacturer

When we use Enamel reactors,we must strictly follow the standard operation because most of the reactants in the equipment are hazardous chemicals.Once a leak occurs,it may cause huge dangers such as explosions,posing a threat to people's health.
The enamel reactor manufacturer below will tell you their emergency solution:
1.When there is a leakage problem during the production reaction process,stop the vehicle promptly and decisively.

2.For newly assembled Enamel reactors,select appropriate sealing gaskets or washers based on the reaction temperature and excitation medium of the equipment,and tighten the sealing bolts.Before use,water should be used instead of material for pressure testing,and soapy water should be applied to the edges of the nozzle and manhole to improve the sealing performance of the joint.

3.When the reactor needs to replace the gasket,ensure that the new gasket is well connected to the flange surface to prevent deformation and unevenness,and then tighten the bolts.During the production process of Enamel reactors,it is necessary to regularly check for leaks and tighten bolts in a timely manner.
4.If the leakage problem cannot be solved by replacing the gasket and tightening the bolt,please contact the manufacturer in a timely manner.
The surface of the enamel reaction kettle is hard and brittle,with low mechanical strength and high surface hardness.It will immediately break under impact.During transportation and installation,the enamel surface often falls off,causing corrosion and even perforation of the storage tank,making it unusable.The product has excellent adhesion,balanced and reasonable chemical and physical properties,fully meets the process requirements of the equipment,saves a lot of funds for the enterprise,optimizes equipment resources,and ensures the reasonable operation of the enterprise mechanism.
In summary,we need to take timely measures to address the leakage problem of Enamel reactors,and pay attention to prevention and maintenance during daily use to ensure the safe and stable operation of the equipment.