China Stainless Steel Reactor manufacturer

After installing the stainless steel reactor, everyone will also install an electrical control cabinet for it. The main function is to control the current of the equipment, so as to provide better power and avoid adverse effects on the equipment caused by excessive or insufficient current. Therefore, it is very important to choose a suitable electrical cabinet for the stainless steel reactor. China stainless steel reactor manufacturer to teach everyone how to choose their electric control cabinet

For stainless steel reactor, the layout of the electrical control cabinet should meet the requirements for normal operation of the power system. It is a control cabinet that is easy to maintain, does not endanger personnel and surrounding equipment. Including distribution cabinets, distribution boxes, electrical control cabinets, etc. During normal operation, the circuit can be turned on or off manually or automatically. Or when the fault runs abnormally, the circuit is cut off or an alarm is triggered through protective devices. Measuring instruments can display various parameters during operation, adjust some electrical parameters, and prompt or emit signals that deviate from normal working conditions. Commonly used for power generation, distribution, and substations.

In the secondary circuit of a general low-voltage electrical control cabinet, the cross-sectional area of the small wiring in the voltage circuit is 1.5 square meters, and the cross-sectional area of the small current circuit is 2.5 square meters. The current circuit of the electric control cabinet of the enamel glass reactor refers to the current signal lines of current transformers, ammeters, power factor meters, mutual inductance energy meters, etc. The current flowing through it is 5 amperes. In addition, the power cord of the electrical control cabinet is yellow green red, and the neutral wire is blue or light blue. The main circuit should have a black line of at least 1.5 square millimeters, a red line of at least 1.0 square meter for AC voltage, and a blue line of at least 1.0 square meter for DC voltage. The color of the signal line can be random and there are no hard requirements.

Therefore, when installing an electrical control cabinet for a stainless steel reactor, this article can be used as a reference to help you quickly choose a more suitable electrical control cabinet.